Using these materials can run reproduction on products as diverse as plaster, plastic, cement, and waxes. There are many types of materials that you can use to produce molds, depending on how the original model will be carried out, in the way it will need reproduction and levels required details. You can use a blade or scissors to cut any excessive silicon covering the back of your molded piece to easily unmold it. Gently push the silicon mold out of the housing. Along with the the silicon cured, try to peel off the glue gun, and tape from the backside. If your silicone does not harden properly, you did not follow the measurement and mixing steps properly. It may take a few more hours, but when it hits the surface, it should harden. Step 5.With attention, the silicon should stand for at least 12 hours to harden. In the meantime, move your hand inside the shell, gently covering the empty space first. Now, start slowly pouring the silicone into the mold, try to pour evenly and thinly holding the cup a little away from the mold. When you’re done mixing, you’re ready to tap. This ensures better mixing and fewer bubbles that form inside. Moreover, remember scraping the sides with a wooden stick. Carefully measure the weight of parts A and B, stirring slowly for at least 3-5 minutes. You are now ready to mix the silicon to resin ratio of 1: 1. All things considered, you have now completed the first important part of mold preparation. Place your design correctly inside the case, face-up, gluing the back to the resin strip, and leaving enough space on the side for the silicone to be poured. Then, carefully use a glue gun to glue and coat the edges of the case on the tape, which will ensure that silicon does not leak out of the case. Take the appropriate size of shell, glue the backside with resin tape and place it on a flat surface to work on. With this step-by-step guide, even you as a beginner will have no problem creating a successful mold. Packing tape, plastic sheets, or anything similar(base for your mold)Īt first glance, it probably seems very difficult to make resin molds.Something you'll put in your resin (use colors, charms, and flowers).Cookie cutters or cardboard(Border for your mold).Clean the surface and gently clean the inside with soap and water if necessary. Never use direct heat on molds, burn them, and clean with adhesive tape. It doesn’t matter if it’s a little sticky.ĩ. Be sure to wait for the mold to harden for at least 12 hours before using the resin.Ĩ. While stirring, stir the silicon for at least 3 minutes, depending on the amount to mix well and reduce bubbles.ħ. When mixing silicon, use a 1: 1 weight ratio for best results.Ħ. The housing can be metal, hard plastic, or cardboard.ĥ. This way you do not waste silicone filling unnecessary gaps and you have enough space so that the mold does not break due to the thin layer of silicone. Choose the right housing for your design, taking into account enough space on the side and the depth of the final mold. To achieve the result of a glossy surface, your original design should have a glossy surface, you can varnish or coat the surface design with a layer of resin and completely harden to the touch.Ĥ. With clean hands, make sure that the surface you are working on is flat and level so that the silicone is evenly distributed.ģ. When you start making resin molds, hair and particles like to sit on silicone, so always clean their surfaces before you start.Ģ. 4 Different Types of Mold Making Materialsġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |